Attendant Disable Outgoing Co Line; Attendant Override - Vodavi STARPLUS Triad-S Manual

3-12
Chapter 3 - Attendant Features and Operation
4. Hang up to complete the transfer.
Conditions
»
If the desired party is an intercom station, that station is signaled according to their
intercom selector/H-T-P switch (SLT stations tone ring).
»
If the desired party is associated to a speed dial bin, the system selects a CO line and dials
the number programmed into the speed dial bin. Call progress tones are then heard.
»
If station is in Directory Dialing mode and a CO or intercom call rings in, the station must
exit Directory Dialing mode to answer the call.

Attendant Disable Outgoing CO Line

Description
The first Attendant can disable CO lines to prevent outgoing access to those lines. This is
useful for removing a faulty line from service or for reserving CO lines for important use. All
stations that normally make calls on the lines are affected, but incoming calls are unaffected.
A CO line may be disabled while it is being used. When the trunk becomes idle, further
outgoing access is prevented.
Operation
To disable CO Lines:
1. Lift handset or press ON/OFF button.
2. Dial [602] on the dial pad. A confirmation tone sounds.
3. Press the line button(s) of the CO Line(s) to disable. A confirmation tone sounds and the
CO Line button(s) LED flashes.
To reactivate the CO Line(s):
Repeat Steps 1-3 to disable this feature.

Attendant Override

Description
Attendant stations may override a busy station or ring a station in DND. While busy, pressing
the override key provides override tone and a five second delay before voice cut-through to
the called party occurs, automatically placing any outside line call on Hold. The Attendant
Override function must be programmed onto a flexible button and can be enabled or
disabled.
Calls may be transferred to internal stations only. An attempt to transfer a call
off-net (via a speed dial bin) results in the call recalling upon going on-hook.
Attendant Disable Outgoing CO Line