Vodavi STARPLUS Triad-S Manual page 181

Keyset Mode
The following Modes are described:
Inactive -- No CTI information is sent/received by the telephone.
PC Phone -- CTI information used with Vodavi Discovery Desktop and Discovery PC Phone
software must be set to 4800 baud rate.
ATD -- This is the modem dialing command. The telephone recognizes the ATD and
accepts digits after the command. This allows the PC connection to the telephone to use
the AT Ringing command. (Available baud rates are: 1200, 2400, and 4800.)
ATH or ATHX (X = 0 or 1) -- This is the modem on hook/off hook command. ATH or ATH0
forces the telephone to the on hook state from its current state. ATH1 forces the
telephone to the off hook state from its current state.
CKTU -- Cordless Key Telephone Unit. This mode is used when the optional Wanderer is
connected to the station. (Refer to the Wanderer User Guide for additional information.)
SPI -- Service Provider Interface. This mode is used in conjunction with TAPI applications
such as Discovery Link.
TAPI -- For future use.
Use Flash 50 programming when you want to modify a range of stations' attributes using
fixed station numbers.
Use Flash 51 programming to modify a single station's attributes using a flexible station
number.
Programming Steps
1. Press FLASH and dial [50] or dial [51]. Flexible button #24 (New Range) is lit and one of
the following messages displays:
S TAT IO N AT T R IB UT E S
S E L E CT A S TATI O N R A N G E
2. Enter the range of fixed station numbers (100-131) to be programmed. If only one station
is being programmed, enter that number twice, e.g., [100 100].
-or-
Enter a valid flexible number (100-8999) to be programmed.
If the handset is off hook (lifted), these commands are discarded and no action is
taken by the telephone.
Flash 50 - Fixed Numbers
If HOLD is pressed without entering a station range, ALL stations are selected.
Chapter 2 - Features and Operation
Flash 51 - Flexible Numbers
E N T E R S TAT IO N N U M B E R
2-155