Timer Setting And Options - Edwards nEXT730D Instruction Manual

The reply will be as follows:
Command
The normal speed is now stored in memory within the nEXT pump.
To check what normal speed is set, send a query as follows:
Command
The reply will be as follows:
Reply

6.1.8 Timer setting and options

The timeout period is a user-configurable option and can be set to any value from
1 to 30 minutes.
When the pump is shipped, it is configured with a default timeout period of 8 minutes.
Refer to Timer
To change the timer setting, send the following command (where the characters 'd'
represent the timeout period in minutes):
Command
The reply will be as follows:
Reply
The Timer setting is now stored in memory within the nEXT pump.
To check what time‑out period is set, send a query as follows:
Command
The reply will be as follows:
Reply
The timer is permanently enabled during ramp‑up, however it is optional whether to
have it enabled at other times. When the pump is shipped, the Timer is enabled by
default.
To disable the timer, send the following serial command:
Command
The reply will be as follows:
Reply
The state of the timer option is stored in memory within the nEXT pump.
To enable the timer again, send the following serial command:
Command
The reply will be as follows:
Reply
B8J200880_D
300812671_002_C3
B8J200880_D - Configuration
* S
?
= S 8
on page 16 for a full description of timer functionality.
! S
* S
?
= S
! S
* S
! S
* S
Page 71
8 5 6
S 8 5
5 6 sp
8 5 4 sp
8 5 4
S 8 5
8 5 4 sp
8 7 0
8 7 0
8 7 0
8 7 0
08/2021 - ©Edwards Limited
sp r cr
6 cr
d d d cr
d d cr
sp r cr
4 cr
d d cr
sp 0 cr
sp r cr
sp 1 cr
sp r cr