Analogue Signal Options; Electronic Braking Options - Edwards nEXT730D Instruction Manual

To check whether the timer is enabled or disabled, send the following query:
Command
The reply will be as follows (where d=0 means disabled and d=1 means enabled):
Reply

6.1.9 Analogue signal options

The analogue output can be used to monitor one of five different parameters.
Table 18 Analogue signal options
Option number
To configure the analogue output, send the following command (where the character 'd'
denotes the option number.
Command
The reply will be as follows:
Reply
The analogue output signal setting is now stored in memory within the nEXT pump.
To check which analogue output signal setting is enabled, send a query as follows:
Command
The reply will be as follows:
Reply

6.1.10 Electronic braking options

Refer to Electronic braking
feature. To enable Electronic Braking, send the following serial command:
Command
The reply will be as follows:
Reply
The state of the Electronic Braking option is stored in memory within the nEXT pump.
To disable the Electronic Braking again, send the following serial command:
Command
B8J200880_D
300812671_002_C3
B8J200880_D - Configuration
=
Description of analogue output number
Measured pump rotational speed. This is the factory default set-
0
ting.
1 Measured link power
2 Measured motor temperature
3 Measured motor controller temperature
4 Measured bearing temperature
!
*
=
on page 17 for a full description of the electronic braking
!
*
!
? S 8
S 8 7
S 8 7
S 8 7
? S 8
S 8 7
S 8 7
S 8 7
S 8 7
Page 72
7 0 cr
0 sp d cr
1 sp d cr
1 sp d cr
7 1 cr
1 sp d cr
2 sp 1 cr
2 sp r cr
2 sp 0 cr
08/2021 - ©Edwards Limited