Interface Cable; Nst2 Pc Program; Auxiliary Connector; Auxiliary Extension Cable - Edwards nEXT730D Instruction Manual

Table 44 PRX purge restrictor
Item
PRX10 purge restrictor

14.8 Interface cable

An interface cable connects the nEXT pump to a PC. Serial commands are then used to
control and monitor the nEXT pump.
Table 45 Interface cable
Item
nEXT Interface cable

14.9 nST2 PC program

The nST2 PC program is PC-based software that can be used with the nEXT pump, either
via the serial interface or via the USB service port.
It can be used to control, monitor, configure and data log the nEXT pump, and also to
view service status, reset service intervals and upgrade the software embedded in the
motor controller.
This software is available for download from the Edwards upgrades website:
www.upgrades.edwardsvacuum.com

14.10 Auxiliary connector

Enables the use of accessories that do not come prewired with a mating plug. Cable
length is 1.5 m.
Table 46 Auxiliary connector
Item
nEXT auxiliary connector

14.11 Auxiliary extension cable

The cable extends the distance of the accessory to the pump and benefits from a right
angled plug to accommodate installation where space is limited. Cable length is 0.2 m.
B8J200880_D
300812671_002_C3
B8J200880_D - Accessories
Page 112
Item Number
B58065001
Item Number
B80000808
Item Number
B8G200839
08/2021 - ©Edwards Limited