Assembly Procedures - Olympus BX53M Instructions Manual

8-2 Assembly procedures

Assemble the units using the Allen screwdriver (opposite side: 3 mm
(opposite side: 4 mm
specified.
Before attaching units, remove dust and dirt from the attaching area and attach units carefully so as
NOTE
not to scratch them.
a
2
b
94
or 3 mm ) provided with the microscope. Use the Allen screwdriver if not
Attaching the overturning prevention plate
If the height of the microscope is increased by the accessories
combined, there is a risk that the microscope may overturn. To
prevent the microscope from overturing, the overturing prevention
1
plate must be attached.
1
Tilt the microscope frame so that the back of the microscope frame
faces down.
2
Align the screw holes a (2 positions) on the bottom of the microscope
frame with the mounting holes b (2 positions) of the overturing
prevention plate, and tighten the provided screws to secure the
overturing prevention plate.
If you lost the overturning prevention plate, contact Olympus and
purchase the following parts.
· Overturning prevention plate (Parts No. AW3640)
· Clamping screw for overturning prevention (Parts No. JA5284)
) and the Allen wrench