Olympus BX53M Instructions Manual page 125

c
a
3
b
This picture shows the procedure to attach the
hand switch for motorized nosepiece (BX3M-
HSRE). The same procedure applies when
attaching the hand switch for exposure (U-HSEXP).
19
Attaching the hand switch
This system can be attached with following three types of the hand
switch.
· Hand switch (BX3M-HS) (Use by place on the table.)
· Hand switch for motorized nosepiece (BX3M-HSRE) (Use by
placing on the table or attaching to the microscope frame.)
· Hand switch for exposure (U-HSEXP) (Use by placing on the table
or attaching to the microscope frame.)
1
Connect the cable for the hand switch to the connector of the control
box (BX3M-CB). For details, see "Cable connections" (page 115).
Attaching to the microscope frame (BX3M-HSRE or U-HSEXP)
The hand switch for motorized nosepiece and the hand switch for
exposure are attached with a magnet. By attaching the iron circular
plate to the microscope frame, the hand switches can be secured to
the circular plates.
1
Attach the circular plate b to the magnet at the bottom of the hand
switch a . Do not remove the paper from the adhesive surface of the
circular plate until the attaching position is determined.
2
Determine the attaching position c (
right coarse focusing knob, where you can easily operate the hand
switch.
Be careful, if the attaching position is too close to the coarse
focusing knob, it may collide with the pre-focusing lever.
3
Wipe the expected attaching position with the absolute alcohol.
Remove the paper from the adhesive surface of the circular plate, and
push the hand switch to the microscope frame to adhere it.
The hand switch for motorized nosepiece and the hand
NOTE
switch for exposure are attached with the magnet. Keep
the objects susceptible to magnetism away from the hand
switches.
If the cables of the hand switch interfere the operation, bundle
TIP
the cables with the provided Velcro.
BX53M
part) around the left or
119