Assembly Procedures - Olympus BXFM Instructions Manual

9-2 Assembly procedures

Assemble the units using the Allen screwdriver (opposite side: 3 mm
(opposite side: 4 mm
Before attaching units, remove dust and dirt from the attaching area and attach units carefully so as
NOTE
not to scratch them.
a
b
This picture shows the procedure to attach the
Illuminator holder for BXFM-S (BXFM-ILHS). The
same procedure also applies when attaching
other illuminator holders.
c
e
64
) provided with the microscope. Use the Allen screwdriver if not specified.
1
2
d
Attaching the illuminator holder
1
Align the mounting hole a of the BXFM frame (BXFM-F) with the screw
holes b (4 positions) of the illuminator holder, and tighten the screws
(4 pcs.) provided with the illuminator holder to secure the illuminator
holder using the Allen screwdriver.
To obtain the reference position, clamp the illuminator holder
TIP
by attaching it completely to the bottom and right side of
concave area of the BXFM frame.
Attaching the Assist spring for BXFM
When using the illuminator holder for BXFM (BX3M-ILH),
TIP
attach the assist spring for BXFM if required.
1
Place the BXFM frame (BXFM-F) upside down.
2
Align the mounting hole c of the BXFM frame (BXFM-F) with the screw
holes d (4 positions) of the assist spring for BXFM (BXFM-ILHSPU),
and tighten the screws (4 pcs.) provided with the assist spring for
BXFM to secure the assist spring for BXFM using the Allen screwdriver.
To obtain the standard position, push the assist spring to the
TIP
right side completely and secure it keeping it contacted to the
positioning surface e .
) and the Allen wrench