Olympus BX53M Instructions Manual page 111

a
2
1
b
Attaching the coded nosepiece
5
Connect the cable that comes out to the back of the microscope frame
in
"Cable connections" (page 115).
NOTE
Attaching the motorized nosepiece
5
Set the number of objective mounting holes of the nosepiece using
the dip switch on the side of the control box (BX3M-CB). For details,
see "Attaching the control box" (page 100).
12
Attaching the MIX slider / DIC slider for reflected light observation
1
Loosen the mounting knob a on the front of the nosepiece and pull
out the dummy slider.
2
Insert the DIC slider for reflected light observation or the MIX slider for
reflected light observation into the slider insertion slot of the nosepiece
by paying attention to the orientation of the slider, and stop inserting
at the first level (when the clicking sound is heard at first).
Orientation of the slider when inserting
DIC slider for reflected light observation: Set the display surface facing
up. ( b )
c
MIX slider for reflected light observation: Set the connector to the right
side. ( c )
3
Tighten the mounting knob a to secure the slider.
When the MIX slider for reflected light observation is attached
4
Connect the cable to the connector of the control box (BX3M-CB). For
details, see Cable connections (page 115).
3
to the connector of the control box (BX3M-CB). For details, see
· When attaching or detaching the nosepiece attached with
the cable, be sure to remove the cable from the connector
in advance.
· If you want to change the nosepiece to the motorized
nosepiece when using the system combined with the
manual nosepiece, remove the reflected light illuminator
together when removing
In order to combine the motorized nosepiece, the cable
for motorized nosepiece (BX3M-RMCBL) must be attached
before attaching the reflected light illuminator. For details,
see "Attaching the cable for motorized nosepiece" (page 101).
BX53M
the manual nosepiece.
105