Polaris RANGER XP 900 2018-2019 Service Manual page 156

ENGINE / COOLING / HVAC SYSTEM
16. Lift the oil pump drive chain and install the oil pump.
17. Install dowel pins (C) into oil pump mounting holes.
18. Install the three bolts (D) that retain oil pump (E) to
the crankcase. Torque
specification.
TORQUE
Oil Pump Mounting Bolts:
7 lb-ft (10 Nm)
3.76
mounting bolts to
9929399 R01 - 2018-2019 RANGER XP/ CREW 900/1000 Service Manual
19. Reinstall oil pump pick-up (F) if previously removed.
Torque mounting screws to specification.
TORQUE
Oil Pump Pick-Up Retaining Screws:
7 lb-ft (10 Nm)
20. Clean the gasket sealing surfaces on oil sump cover
and crankcase to remove old gasket material and
any oil.
IMPORTANT
Gasket surfaces must be DRY and oil free. Use care
upon assembly to keep oil away.
21. Apply a thin, continuous film of Crankcase Sealant
(PN 2871557) to sump cover mating surface as
shown. Do not allow sealant to dry before assembly.
CAUTION
Dipstick must be removed before oil pan is assembled
to the engine. Failure to do this will damage the
dipstick.
© Copyright Polaris Industries Inc.