Polaris RANGER XP 900 2018-2019 Service Manual page 377

7. Install the torsion spring by wrapping each leg of the
spring around the dowel pin on the ring gear.
8. Install the rollers and roll cage into the ring gear.
Insert the rollers as the roll cage is installed.
a
9. Install the pins , roll cage
i
assembly into the gearcase housing.
10. Align the spring retainer dowel pin with the ring gear
dowel pin and install the retainer
torsion spring.
9929399 R01 - 2018-2019 RANGER XP/ CREW 900/1000 Service Manual
© Copyright Polaris Industries Inc.
11. Check the action of the torsion spring by rotating in
both directions to ensure the spring and retainer are
installed properly.
12. Install the armature plates
plate tabs are fully engaged into the roll cage
assembly.
o
, and ring gear
Verify armature plate tabs are in the slots on the roll
13. Install the RH output hub
housing. The output hub should spin freely.
y
on top of the
t
. Be sure the armature
NOTICE
cage and are resting in the ring gear grooves.
e
FINAL DRIVE
7
into the gearcase
7.29