Intake Manifold Removal - Polaris RANGER XP 900 2018-2019 Service Manual

ENGINE / COOLING / HVAC SYSTEM

INTAKE MANIFOLD REMOVAL

1. If vehicle was recently operated, allow it to cool down
before attempting to perform any work.
2. Thoroughly clean the engine and chassis.
3. Remove rear cargo box from vehicle. Refer to
"Cargo Box Removal"page 10.27 procedure.
4. Loosen the clamp holding the engine intake hose to
the throttle body. Place clean cloth inside throttle
body inlet to prevent any contaminants from entering
the engine.
5. Carefully remove electrical harness from fuel injectors
q w
, TMAP sensor , and Throttle Body
3.100
6. Disconnect Turf Mode connector
7. Disconnect Transmission
y
and Speed Sensor
tabs and position harness out of the way.
e
.
8. Remove the Fuel Line by pulling open the connector
tab
line.
Place a shop towel around the fuel line to catch any
9929399 R01 - 2018-2019 RANGER XP/ CREW 900/1000 Service Manual
t
u
. Remove clips from retaining
i
while moving the connector out to release the
IMPORTANT
dripping fuel.
© Copyright Polaris Industries Inc.
r
.
, CPS Switch connector