Transmission (Gear Position) Switch; Seat Belt Switch - Polaris RANGER XP 900 2018-2019 Service Manual

ELECTRICAL

TRANSMISSION (GEAR POSITION) SWITCH

The transmission switch is located on the right side of the
transmission. The switch can be accessed through the
right rear wheel well opening.
1. Disconnect the transmission switch harness by lifting
the connector lock and pulling on the 2-pin
connector. Do not pull on the wiring.
2. Test transmission switch for continuity in each gear
position and compare to the specifications below.
11.8

SEAT BELT SWITCH

The vehicle is equipped with a seat belt interlock switch
to prevent the vehicle from exceeding 15 MPH (24 KPH)
unless the driver seat belt is secured in the seat belt lock.
The switch is powered by the EFI Relay, sending a signal
to the ECU.
1. Disconnect the
depressing the connector locks and pulling on the
connector. Do not pull on the wiring.
2. Test for continuity between the EFI Relay and the
switch.
3. Test for continuity between the switch and the ECU
pin.
4. Test for continuity across the switch.
Seat Belt Switch: Normally Open
9929399 R01 - 2018-2019 RANGER XP/ CREW 900/1000 Service Manual
seat belt switch harness
© Copyright Polaris Industries Inc.
by