Wheel Toe Adjustment - Polaris RANGER XP 900 2018-2019 Service Manual

STEERING / SUSPENSION

WHEEL TOE ADJUSTMENT

If toe alignment is incorrect, repeat steps 3-5 of "Wheel
Toe Alignment Inspection", but instead measure the
distance between vehicle center and each wheel. This
will tell you which tie rod needs adjusting.
NOTICE
Be sure steering wheel is straight ahead before
determining which tie rod needs adjustment.
CAUTION
During tie rod adjustment, it is very important that the
following precautions be taken when tightening tie rod
end jam nuts. If the rod end is positioned incorrectly it
will not pivot, and may break.
To adjust toe alignment:
• Hold tie rod end to keep it from rotating.
• Loosen jam nuts at both end of the tie rod.
8.12
• Shorten or lengthen the tie rod until alignment is as
required to achieve the proper toe setting as specified
in "Wheel Toe Alignment Inspection".
IMPORTANT
When tightening the tie rod end jam nuts, the rod ends
must be held parallel to prevent rod end damage and
premature wear. Damage may not be immediately
apparent if done incorrectly.
• After alignment is complete, torque jam nuts to
specification.
Tie Rod Jam Nut:
13 lb-ft (18 Nm)
9929399 R01 - 2018-2019 RANGER XP/ CREW 900/1000 Service Manual
TORQUE
© Copyright Polaris Industries Inc.