Cooling System Hoses - Polaris RANGER XP 900 2018-2019 Service Manual

MAINTENANCE
3. Check the coolant level in the recovery bottle. The
coolant level must be maintained between the "MAX"
and "MIN" levels indicated on the recovery bottle
4. If the coolant level is below the "MIN" mark, inspect
the coolant level in the radiator.
NOTICE
If overheating is evident, allow system to cool
completely and check coolant level in the radiator and
inspect for signs of trapped air in system.
CAUTION
Never remove the pressure cap when the engine is
warm or hot. Escaping steam can cause severe burns.
The engine must be cool before removing the pressure
5. Remove the pressure cap. Using a funnel, add
coolant to the top of the radiator filler neck.
6. Reinstall the pressure cap.
NOTICE
Use of a non-standard pressure cap will not allow the
recovery system to function properly.
7. Remove the recovery bottle cap and add coolant
using a funnel.
8. Fill the recovery bottle to the "MAX" mark with the
recommended pre-mix coolant. You may use a 50/50
or 60/40 mixture of antifreeze and distilled water as
required for freeze protection in your area.
FLUID CAPACITY
Recommended Anti-Freeze/Coolant:
Premium Pre-Mixed Extended Life Antifreeze
(PN 2880514) (Quart)
(PN 2880513) (Gallon)
9. Reinstall the recovery bottle cap.
2.22
cap.
10. If coolant was required, start engine and check for
leaks. Make sure radiator fins are clean to prevent
overheating.

COOLING SYSTEM HOSES

1. Inspect all vehicle hoses for cracks, deterioration,
abrasion or leaks. Replace if necessary.
2. Inspect all engine hoses for cracks, deterioration,
abrasion or leaks. Replace if necessary.
3. Check tightness and condition of all hose clamps. Do
not over-tighten hose clamps at radiator, or radiator
fitting may distort.
Radiator Hose Clamp:
3 lb-ft (4 Nm)
9929399 R01 - 2018-2019 RANGER XP/ CREW 900/1000 Service Manual
TORQUE
© Copyright Polaris Industries Inc.