Polaris RANGER XP 900 2018-2019 Service Manual page 171

14. If timing marks are not aligned, remove sprockets
and correct alignment.
15. Remove the Cylinder Holding & Camshaft Timing
Plate (PU-50563) from the end of the camshafts.
16. Rotate the engine using the flywheel and install the
remaining bolt in each camshaft sprocket. Torque the
sprocket bolts to specification.
TORQUE
Camshaft Sprocket Bolts:
14 ft-lb (19 Nm)
17. Rotate the engine using the flywheel and torque the
remaining sprocket bolts to specification.
18. Install the front camshaft carrier
retaining bolts.
19. Install the fixed cam chain guide
bolts.
9929399 R01 - 2018-2019 RANGER XP/ CREW 900/1000 Service Manual
© Copyright Polaris Industries Inc.
20. Torque the camshaft carriers bolts in sequence to
specification.
o
and two outer
21. Apply Polaris PS-4 engine oil to the cam chain
tensioner bore prior to assembly. Use a new
tensioner sealing washer
22. Install the hydraulic cam chain tensioner
cylinder and torque to specification.
a
and two retaining
23. Rotate crankshaft through two revolutions and verify
camshaft timing is correct.
ENGINE / COOLING / HVAC SYSTEM
TORQUE
Camshaft Carrier Bolts:
7 ft-lb (10 Nm)
d
.
TORQUE
Cam Chain Tensioner:
30 lb-ft (40 Nm)
3
s
into the
3.91