Reinstalling Calibration Files - Micromeritics DVVA II 4000 Operator's Manual

Using the Setup Program for Other Functions

Reinstalling Calibration Files

Calibration files specific to the analyzer are contained on the original program CD; they are not
contained on an update CD. It is important that you store your original program CD in a safe
location. Part numbers for CDs containing calibration files have a suffix of 99. Part numbers for
Update CDs have a suffix of 00.
Reinstall calibration files as follows:
1. Start the Setup program. Refer to
10.
2. Select Re-install calibration files for an analyzer, then click
calibration files dialog is displayed.
If you did not use the original program CD to start the Setup program, you will have to
insert it now since it contains the calibration files. You do not have to exit the Setup
program. Simply remove the CD and insert the program CD.
3. Ensure that the CD drive is displayed as the Calibration file source location. If not, click
and choose the CD drive.
Browse
4. Click
Next
5. Click
Exit
4-18
Using the Setup Program for Other
; the calibration files are reinstalled and the Welcome dialog is displayed.
to close the dialog.
DVVA II 4000
Functions, page
; the Re-install
Next
400-42803-01 (Rev B) - July 2017
4-