Micromeritics DVVA II 4000 Operator's Manual page 120

Sample Analysis
Browse
Sample
Material Properties
Replace All
Analysis Conditions
Report Options
Mass
Skeletal Density
Bulk Density
Scan Rate
Ending Pressure
Recording Interval
Use Prior Blank
Measure Residual volume
Time Between Cycles
6-4
Allows you to select a different sample file for your analysis, or
to create a new one.
Displays the identification of the sample file.
Defaults to the type of material you selected on the sample
information dialog; ensure that it displays the correct type
The Material type is used to determine which carbon property
models are used for this particular carbon. For example, a
different equation is used to predict COAN for Tread/Hard
carbons than for Carcass/Soft carbons. If you select Other, the
COAN is not calculated.
Choose Other only when your material is something other than
Tread/Hard or Carcass/Soft.
Enables you to replace the values for all parameters of the
current file with those from an existing file.
Displays a description of the analysis conditions file in the
selected sample information file.
Use the drop-down list to select a different Analysis Conditions
file.
Displays a description of the report options file in the sample
information file you have chosen for this analysis.
Use the drop-down list to select a different Report Options file.
Displays the values specified in the current sample information
file.
These values can be edited if necessary.
Displays the values and options specified in the current
Analysis Conditions file; any can be edited for the current
analysis. Editing the values on this dialog will not change those
of the Analysis Conditions file.
DVVA II 4000
400-42803-01 (Rev B) - July 2017