Micromeritics DVVA II 4000 Operator's Manual page 168

Sample Defaults
Operator
Submitter
Bar Code
Mass
Skeletal Density
8-8
Enter the name (or other identification) of the operator
performing the analysis and the name of the person, department,
customer, etc. that submitted the sample for analysis.
The fields on the left can be edited to display something other
than Operator and Submitter if desired. You can use up to 20
characters in each field.
The fields on the right are used to specify default names or
titles, or leave them blank and enter names when the files are
created.
• Include the automatically generated file name (number) by
using the symbol $ where you want the sequence number to
appear. Refer to the example given above.
• Use up to 42 characters (including the $ symbol)
• Select Omit to prevent this item from displaying on the sam-
ple file dialog
This field enables you to enter bar code information. If bar code
information is not used, you can use this field to enter additional
information about the sample; for example, you may wish to
enter the lot number of your sample.
This field, as well as other fields on the dialog, accepts data
from a bar code reader. A bar code reader can be attached to one
of the USB connectors on the computer. Simply scan the bar
code and the number transfers to the highlighted field.
Range: 40 alphanumeric characters
The label for this field may be customized to display differently
or omitted from displaying at all using the options available in
Defaults, page 8-6.
Sample
Enter a default value for the sample's mass; 1.0000 gram, ± 0.05
(determined to nearest 0.0001 gram) is the recommended
amount of sample to use.
Enter the skeletal density (also known as the true density) of
your most commonly analyzed sample.
DVVA II 4000
400-42803-01 (Rev B) - July 2017