Zcontdrv - Canon MARKLL WUX10 Command List

ZCONTDRV

Zoom lens continuous drive control
Format
ZCONTDRV=<Zoom lens continuous control parameter:ID>
<Zoom lens continuous control parameter:ID>
STOP
WIDE
TELE
Environment
Power
OFF ON
X O
Response
"i:OK" is returned when the drive was completed successfully.
For details on other responses, refer to the "Error List".
Description
(1) This command is used to drive the zoom lens continuously.
(2) This command functions in the same way as when first the "ZOOM" button on the remote
control or main unit panel is pressed and then the "↑" or "↓" button is pressed.
(3) Zoom drive is started by specifying "TELE" or "WIDE".
To stop the drive, send the "ZCONTDRV=STOP" command.
If no instruction was given to stop the drive, the drive stops at the drive direction end.
(4) The following commands are acknowledged during zoom drive, but zoom drive will also stop at
the same time.
a. POWER
b. ZCONTDRV=STOP
(5) The following commands are acknowledged during zoom drive, and a response is returned
while the drive continues.
a.
b.
c.
d.
(6) There are no GET commands available for this command.
Example
Control
> ZCONTDRV=TELE
< I:OK
* Commands are indicated by ">", and responses are indicated by "<".
Revision History / Date
This stops the zooming.
This zooms to the wide-angle end.
This zooms to the telephoto end.
PM D-RGB A-RGB1 A-RGB2 COMP
X
GET MODE
GET POWER
GET ERR
GET LAMPCOUNTER
Control over the zooming to the telephoto end is started.
Changes
Projector WUX10 MarkII User Commands
Input
VIDEO HDMI
-
e. GET PRODCODE
f. GET ROMVER
g. GET COMVER
h. REMOTE
- 79 -
None
i. LOCAL
j. RC
k. MAIN
l. [NULL]
Revised by
Approved by