ELECTRICAL
IGNITION COIL AND HT LEAD
REPLACEMENT
1. Remove the drivers seat and disconnect the (-)
negative battery cable.
2. Disconnect harness connection to the ignition coil.
3. Remove high tension lead cap
plug.
w
4. Remove fasteners
remove coil assembly from the vehicle.
5. Install new ignition coil assembly and tighten
fasteners to specification.
Be sure to reinstall the coil mounting spacers upon
assembly (if equipped).
TORQUE
Ignition Coil Retaining Bolt:
75 in-lbs (8.5 Nm)
6. Connect harness connection to the ignition coil.
7. Reconnect battery cable and install the drivers seat.
11.20
q
from the spark
retaining the ignition coil and
NOTE
9928485 R01 - 2017-2018 RANGER 500 / 570 Service Manual
© Copyright Polaris Industries Inc.