Server Control; Cli Configuration - Tripp Lite NGI-S04C2 Owner's Manual

Parameter
Port Security Settings
Port Security
Port
State
Maximum MAC
Port Security Status
Port
State
Maximum MAC

6.4. Server Control

Introduction
The function allows users to enable or disable the HTTP, HTTPS, SNMPv1/v2c,
SNMPv3, SSH and Telnet service individually.
6.4.1.

CLI Configuration

Node Command
enable show server status
configure ssh server
configure no ssh server
configure telnet server
configure no telnet server
configure SNMPv1/v2c
configure SNMPv1/v2c
configure SNMPv3
configure SNMPv3
configure web server
configure no web server
Description
Select Enable/Disable to permit Port Security on the Switch.
Select a port number to configure.
Select Enable/Disable to permit Port Security on the port.
The maximum number of MAC addresses allowed per
interface. The acceptable range is 1 to 1000.
This field displays a port number.
This field displays if Port Security is Enabled or Disabled
This field displays the maximum number of MAC addresses
This command displays the current server status.
This command enables the ssh on the Switch.
This command disables the ssh on the Switch.
This command enables the telnet on the Switch.
This command disables the telnet on the Switch.
This command enables the SNMPv1/v2c on the
Switch.
This command disables the SNMPv1/v2c on the
Switch.
This command enables the SNMPv3 on the Switch
This command disables the SNMPv3 on the
Switch.
This command enables the web on the Switch.
This command disables the web on the Switch.
93
Description