Web Configuration - Tripp Lite NGI-S04C2 Owner's Manual

(disable/enable)
configure snmp trap-event
stp-topology-change
(disable/enable)
configure snmp trap-event
traffic-monitor
(disable/enable)
8.1.3.2.
The features allow users to enable/disables individual trap notification.
Alarm-Over-Heat
Alarm-Over-Load
Alarm-Power-Fail
BPDU-Guard
Loop-Detection
Port-Admin-State-Change
Port-Link-Change
STP-Topology-Change
Traffic-Monitor
.
Parameter
Trap Event State Settings
Select all
Deselect All
This command enables/disables the
stp-topology-change trap.
This command enables/disables
thetraffic-monitor trap.

Web Configuration

- Trap when system's temperature is too high.
- Trap when system is over load.
- Trap when system power is over voltage/under
voltage/RPS over voltage/RPS under voltage.
- Trap when port is blocked by BPDU Guard/BDPU
Root Guard/BPDU port state changed.
- Trap when port is blocked by Loop Detection.
- Trap when port is enabled/disable by administrator.
- Trap when port is link up/down change.
- Trap when the STP topology change.
- Trap when port is blocked by Traffic Monitor.
Description
Enables all of trap events.
Disables all of trap events.
118