Server Control; Cli Configuration - Tripp Lite NGI-S08C2POE8 Owner's Manual

6.4. Server Control

The function allows users to enable or disable the HTTP, HTTPS, SNMPv1/v2c, SNMPv3,
SSH, Telnet service individually.
6.4.1.

CLI Configuration

Node Command
enable show server status
enable configure terminal
configure http server
configure no http server
configure http server port
TCPPORT
configure no http server port
configure https server
configure no https server
configure http server restart
configure snmpv1/v2c
configure no snmpv1/v2c
configure snmpv3
configure no snmpv3
configure ssh server
configure no ssh server
configure telnet server
configure no telnet server
Description
This command displays the current server status.
This command changes the node to configure node.
This command enables the HTTP service on the Switch.
This command disables the HTTP service on the Switch.
This command configures a TCP port for the HTTP
server.
This command reset the TCP port of the HTTP server to
default value (80).
This command enables the HTTPS service on the
Switch.
This command disables the HTTPS service on the
Switch.
This command restart the HTTP server If you have
changed HTTP service state or TCP port of the HTTP
server, you should run this command to let them take
effcts.
This command enables the SNMPv1/v2c service on the
Switch
This command disables the SNMPv1/v2c service on the
Switch.
This command enables the SNMPv3 service on the
Switch
This command disables the SNMPv3 service on the
Switch.
This command enables the SSH service on the Switch.
This command disables the SSH service on the Switch.
This command enables the Telnet service on the Switch.
This command disables the Telnet service on the Switch.
107