Onvif; Cli Configuration - Tripp Lite NGI-S04C2 Owner's Manual

Action
5.2.3.

ONVIF

ONVIF is an open industry forum that provides and promotes standardized interfaces for
effective interoperability of IP-based physical security products.
The Switch uses ONVIF to discover if there is an ONVIF device connected to the Switch.
ONVIF settings and ONVIF Neighbor
The page shows detailed information about ONVIF settings and ONVIF devices
connected to the Switch. The Switch displays ONVIF devices up to total port count,
NGI-S04C2 shows upto 10 ONVIF devices connected to it. If one or more ONVIF
devices are connected to the same port it displays the last ONVIF device gets connect to
it.
5.2.3.1.
Node Command
enable show onvif neighbors
configure onvif enable
configure onvif disable
configure onvif binding-ports
configure no onvif binding-ports
configure onvif tx-interval
<6-3600>
Unit: second. (Default:
6)
configure no onvif tx-interval
Whether to delete entered device or not.

CLI Configuration

This command displays the onvif neighbor
discovery.
This command is used to enable onvif service
on device .
This command is used to disable onvif service
on device .
This command is used to configure onvif
binding ports .
This command is used to delete onvif binding
ports .
This command is used to configure onvif
tx-interval discovery time from the range of
6-3600 seconds default time is 6 seconds.
This command is used to delete onvif
tx-interval discovery time from the range of
6-3600 seconds default time is 6 seconds.
67
Description