Port Mirror; Cli Configuration - Tripp Lite NGI-S04C2 Owner's Manual

RPS
Refresh

7.2. Port Mirror

The Port-Based Mirroring is used on a network switch to send a copy of network packets
sent/received on one switch ports to a network monitoring connection on another switch
port (Destination Port). This is commonly used for network appliances that require
monitoring of network traffic, such as an intrusion-detection system.
Port Mirroring, together with a network traffic analyzer, helps to monitor network traffic.
7.2.1.

CLI Configuration

Node Command
enable show mirror
configure mirror
(disable|enable)
configure mirror destination
port PORT_ID
configure mirror source ports
PORT_LIST mode
(both|ingress|egress)
configure no mirror source ports
PORT_LIST
The procedures to configure the port mirror.
To enter the configure node.

L2SWITCH#configure terminal
L2SWITCH(config)#
To enable the global mirror function.

L2SWITCH(config)#mirror enable
To configure the monitor port to port 2.

L2SWITCH(config)#mirror destination port 2
To configure the source ports which you want to check.

L2SWITCH(config)#mirror source ports 3-6 mode both
The field display the current Redundant Power Supply
Control DIP settings.
Disable – RPS Control controlled by user configurations.
Enable – RPS control is enabled.
Refresh Button will refresh the page to display the applied
changes
This command displays the current port mirroring
configurations.
This command disables / enables the port
mirroring on the switch.
This command specifies the monitor port for the
port mirroring.
This command adds a port or a range of ports as
the source ports of the port mirroring.
This command removes a port or a range of ports
from the source ports of the port mirroring.
106
Description