Web Configuration - Tripp Lite NGI-S04C2 Owner's Manual

4.2.2.2.
Parameter Description
State Select this option to enable loop guard on the Switch.
Enter the destination MAC address the probe packets will be
MAC Address sent to. If the port receives these same packets the port will be
shut down.
Port Select a port on which to configure loop guard protection.
State Select Enable to use the loop guard feature on the Switch.
Select Enable to reactivate the port automatically after the
Loop Recovery
designated recovery time has passed.
Specify the recovery time in minutes that the Switch will wait
Recovery Time before reactivating the port. This can be between 1 to 60
minutes.
Apply Click Apply to save your changes to the Switch.
Refresh Click Refresh to begin configuring this screen afresh.
Loop Guard Status
Port This field displays a port number.

Web Configuration

32