Port Trap Event Settings; Cli Configuration; Web Configuration - Tripp Lite NGI-S04C2 Owner's Manual

Apply
Refresh
8.1.4.

Port Trap Event Settings

The features allow users to enable/disables port-link-change trap notification by
individual port.
8.1.4.1.
Node
enable show snmp port-link-change-trap
interface snmp port-link-change-trap
interface no snmp port-link-change-trap
config interface range (fastethernet1/0/ |
gigabitethernet1/0/) PORTLISTS
if-range snmp port-link-change-trap
if-range no snmp port-link-change-trap
8.1.4.2.
Parameter
Trap Event State Settings
Click Apply to configure the settings.
Click Refresh to begin configuring this screen afresh.

CLI Configuration

Command

Web Configuration

Description
119
Description
This command displays the SNMP
port link-change trap configurations.
This command enables the link
change trap on the specific port.
This command disables the link
change trap on the specific port.
This command enters the interface
configure node.
This command enables the link
change trap on the specific ports.
This command disables the link
change trap on the specific ports.