Cli Configuration - Tripp Lite NGI-S04C2 Owner's Manual

4.2.2.1.
Node Command
enable show loop-detection
configure loop-detection (disable |
enable)
configure loop-detection address
MACADDR
configure no loop-detection
address
interface loop-detection (disable |
enable)
interface no shutdown
interface loop-detection recovery
(disable | enable)
interface loop-detection recovery
time VALUE
configure interface range
gigabitethernet1/0/
PORTLISTS
if-range loop-detection (disable |
enable)
if-range loop-detection recovery
(disable | enable)
if-range loop-detection recovery
time VALUE
Example:
L2SWITCH(config)#loop-detection enable
L2SWITCH(config)#interface 1/0/1
L2SWITCH(config-if)#loop-detection enable

CLI Configuration

This command displays the current loop
detection configurations.
This command disables / enables the loop
detection on the switch.
This command configures the destination
MAC for the loop detection special packets.
This command configures the destination
MAC to default (00:0b:04:AA:AA:AB).
This command disables / enables the loop
detection on the port.
This command enables the port. It can unblock
port blocked by loop detection.
This command enables / disables the recovery
function on the port.
This command configures the recovery period
time.
This command enters the interface configure
node.
This command disables / enables the loop
detection on the ports.
This command enables / disables the recovery
function on the port.
This command configures the recovery period
time.
31
Description