Web Configuration - Tripp Lite NGI-S04C2 Owner's Manual

4.3.2.2.
Parameter Description
Select Enabled to use Spanning Tree Protocol (STP) or Rapid
State
Spanning Tree Protocol (RSTP).
Select to use either Spanning Tree Protocol (STP) or Rapid
Mode
Spanning Tree Protocol (RSTP).
This is the maximum time (in seconds) the Switch will wait
before changing states. This delay is required because every
switch must receive information about topology changes before
Forward Delay it starts to forward frames. In addition, each port needs time to
listen for conflicting information that would make it return to a
blocking state; otherwise, temporary data loops might result.
The allowed range is 4 to 30 seconds.
This is the maximum time (in seconds) the Switch can wait
without receiving a BPDU before attempting to reconfigure. All
Switch ports (except for designated ports) should receive
BPDUs at regular intervals.
Max Age Any port that ages out STP information (provided in the last
BPDU) becomes the designated port for the attached LAN. If it
is a root port, a new root port is selected from among the
Switch ports attached to the network. The allowed range is 6 to
40 seconds.
This is the time interval in seconds between BPDU (Bridge
Hello Time Protocol Data Units) configuration message generations by the
root switch. The allowed range is 1 to 10 seconds.

Web Configuration

49