7.6. Utilization Threshold
This feature alerts the user when the packet rate in the particular port is above the
required rate.
7.6.1.
CLI Configuration
Node
Command
configure
port-utilization
threshold
(disable|enable)
configure
interface IFNAME
Ex: interface 1/0/4
interface
port-utilization
threshold rate (value)
interface
port-utilization
threshold state
(disable|enable)
Example:
L2SWITCH#configure terminal
L2SWITCH(config)#port-utilization threshold enable
L2SWITCH(config)#interface 1/0/4
L2SWITCH(config-if)#port-utilization threshold rate 40
L2SWITCH(config-if)#port-utilization threshold state enable
Description
The command disables / enables the port
utilization threshold function globally.
This command enters the interface configure
node.
This command configures the port-utilization
threshold value
The command disables / enables the port
utilization threshold function on interface.
112