Neighbor Devises; Lldp; Cli Configuration - Tripp Lite NGI-S04C2 Owner's Manual

5.2. Neighbor Devises

5.2.1.

LLDP

Introduction
The Link Layer Discovery Protocol (LLDP) specified in this standard allows stations
attached to an IEEE 802 LAN to advertise, to other stations attached to the same IEEE
802 LAN, the major capabilities provided by the system incorporating that station, the
management address or addresses of the entity or entities that provide management of
those capabilities, and the identification of the station's point of attachment to the IEEE
802 LAN required by those management entity or entities.
The information distributed via this protocol is stored by its recipients in a standard
Management Information Base (MIB), making it possible for the information to be
accessed by a Network Management System (NMS) using a management protocol such
as the Simple Network Management Protocol (SNMP).
Default Settings
The LLDP on the Switch is enabled.
Tx Interval : 30 seconds.
Tx Hold : 4 times.
Time To Live : 120 seconds.
5.2.1.1.
Node Command
enable show lldp
enable show lldp neighbor
configure lldp (disable|enable)
configure lldp tx-interval
configure lldp tx-hold
interface lldp-agent
(disable|enable|rx-on
ly|tx-only)
configure interface range
gigabitethernet1/0/
PORTLISTS

CLI Configuration

This command displays the LLDP configurations.
This command displays all of the ports' neighbor
information.
This command globally enables / disables the
LLDP function on the Switch.
This command configures the interval to transmit
the LLDP packets.
This command configures the tx-hold time which
determines the TTL of the Switch's message.
(TTL=tx-hold * tx-interval)
This command configures the LLDP agent
function.
disable – Disable the LLDP on the specific port.
enable – Transmit and Receive the LLDP packet
on the specific port.
tx-only – Transmit the LLDP packet on the
specific port only.
rx-only – Receive the LLDP packet on the specific
port.
This command enters the interface configure node.
63
Description