Cli Configuration - Tripp Lite NGI-S04C2 Owner's Manual

4.2.1.1.
Node Command
enable show interface IFNAME
configure interface IFNAME
interface show
interface loopback (none | mac)
interface flowcontrol (off | on)
interface speed (auto|10-full||10-half|
100-full|100-half|1000-full)
interface shutdown
interface no shutdown
interface description STRINGs
interface no description
interface cable test
interface clean cable-test result
interface show cable-test result
configure interface range gigabitethernet1/0/
PORTLISTS
if-range description STRINGs
if-range no description
if-range shutdown
if-range no shutdown
if-range speed (auto|10-full||10-half|
100-full|100-half|1000-full)
Example:
L2SWITCH#configure terminal

CLI Configuration

28
Description
This command displays the current
port configurations.
This command enters the interface
configure node.
This command displays the current
port configurations.
This command tests the loopback
mode of operation for the specific
port.
This command disables / enables the
flow control for the port.
This command configures the speed
and duplex for the port.
This command disables the specific
port.
This command enables the specific
port.
This command configures a
description for the specific port.
This command configures the
default port description.
This command diagnostics the
Ethernet cable and shows the broken
distance.
This command cleans the test result
of the Ethernet cable test.
This command displays the test
result of the Ethernet cable test.
This command enters the interface
configure node.
This command configures a
description for the specific ports.
This command configures the
default port description for the
specific ports.
This command disables the specific
ports.
This command enables the specific
ports.
This command configures the speed
and duplex for the port.