Installation - Tripp Lite NGI-S04C2 Owner's Manual

6. If you want to pull the connector out, first push down the release clip on top of
the connector to release the connector from the SFP module.
To properly connect fiber cabling: Check that the fiber terminators are clean. You can
clean the cable plugs by wiping them gently with a clean tissue or cotton ball moistened
with a little ethanol. Dirty fiber terminators on fiber optic cables will impair the quality of
the light transmitted through the cable and lead to degraded performance on the port.
Note: When inserting the cable, be sure the tab on the plug clicks into position to ensure
that it is properly seated.
Check the corresponding port LED on the Switch to be sure that the connection is valid.
(Refer to the LED chart).
Attention:
The NGI-S04C2 is an open type device and NGI-S04C2 shall be DIN-Rail
mounted or wall mounted (optional) in cabinet or enclosure

3.2. Installation

The location chosen for installing the Switch may greatly affect its performance. When
selecting a site, we recommend considering the following rules:
 Install the Switch in an appropriate place. See Technical Specifications for the
acceptable temperature and humidity ranges.
 Install the Switch in a location that is not affected by strong electromagnetic
field generators (such as motors), vibration, dust, and direct sunlight.
 Leave at least 10cm of space at the front and rear of the unit for ventilation.
Hardware Installation
 Step1: Unpack the device and other contents of the package.
 Step 2: Fasten DIN-Rail or Wall-mount kit on the rear of the NGI-S04C2
 Step 3: Connect the 20~60V DC power supply to the PWR & RPS terminal block
r on the top of the Switch (Refer to "Wiring Power Inputs")
 Step 4: Connect the Ethernet (RJ45) port to the networking device and check the
LED status to confirm the connection is established.
DIN Rail Installation
14