Tripp Lite NGI-S04C2 Owner's Manual page 47

counters
enable clear spanning-tree
counters PORT_ID
configure spanning-tree
(disable | enable)
configure spanning-tree
algorithm-timer
forward-time TIME
max-age TIME
hello-time TIME
configure no spanning-tree
algorithm-timer
configure spanning-tree
forward-time <4-30>
configure no spanning-tree
forward-time
configure spanning-tree
hello-time <1-10>
configure no spanning-tree
hello-time
configure spanning-tree
max-age <6-40>
configure no spanning-tree
max-age
configure spanning-tree mode
(rstp|stp)
configure spanning-tree
pathcost method
(short|long)
configure spanning-tree priority
<0-61440>
configure no spanning-tree
priority
interface spanning-tree
(disable|enable)
interface spanning-tree
bpdufilter
(disable|enable)
interface spanning-tree
bpduguard
(disable|enable)
interface spanning-tree
rootguard
(disable|enable)
interface spanning-tree
edge-port
all ports.
This command clears spanning-tree statistics for a
specific port.
This command disables / enables the spanning tree
function for the system.
This command configures the bridge times
(forward-delay,max-age,hello-time).
This command configures the default values for
forward-time & max-age & hello-time.
This command configures the bridge forward
delay time (sec).
This command configures the default values for
forward-time.
This command configures the bridge hello
time(sec).
This command configures the default values for
hello-time.
This command configures the bridge message
max-age time(sec).
This command configures the default values for
max-age time.
This command configures the spanning mode.
This command configures the pathcost method.
This command configures the priority for the
system.
This command configures the default values for
the system priority.
This command configures enables/disables the
STP function for the specific port.
This command configures enables/disables the
bpdufilter function for the specific port.
This command configures enables/disables the
bpduguard function for the specific port.
This command enables/disables the BPDU Root
guard port setting for the specific port.
This command enables/disables the edge port
setting for the specific port.
47