Cli Configuration - Tripp Lite NGI-S04C2 Owner's Manual

you will get an error. If you still want to use this instance, you can change the Control
VLAN to same as the control vlan of the instance first. And then configures the instance.
4.3.1.1.
Node Command
enable show erps
enable show erps instance
enable show erps instance
INSTANCE_ID
configure erps enable
configure no erps enable
configure erps ring-id VALUE
configure erps instance
configure no erps ring-id VALUE
erps-ring show
erps-ring control-vlan
erps-ring guard-timer
erps-ring holdoff-timer
erps-ring left-port PORTID type
[owner|neighbor|norm
al]
erps-ring mel VALUE
erps-ring name STRING
erps-ring revertive
erps-ring no revertive
erps-ring right-port PORTID type
[owner|neighbor|norm
al]
erps-ring ring enable
erps-ring no ring enable

CLI Configuration

This command displays the ERPS
configurations.
This command displays the ERPS instance
configurations.
This command displays the specific ERPS
instance configurations.
This command enables the global ERPS on
the Switch.
This command disables the global ERPS on
the Switch.
This command creates an ERPS ring and its
ID and enter ERPS node.
This command enters the instance configure
node.
This command creates an ERPS ring and
enter ERPS node to configure detail ring
configurations.
This command displays the configurations of
the ring.
This command configures a control-vlan for
the ERPS ring.
This command configures the Guard Timer
for the ERPS ring. (default:500ms)
This command configures the Hold-off Timer
for the ERPS ring. (default:0 ms)
This command configures the left port and
type for the ERPS ring.
This command configures a Control MEL for
the ERPS ring.
This command configures a name for the
ERPS ring.
This command configures the revertive mode
for the ERPS ring.
This command configures the non-revertive
mode for the ERPS ring.
This command configures the right port and
type for the ERPS ring.
This command enables the ring.
This command disables the ring.
38
Description