Configuration; Wizard Settings - Tripp Lite NGI-S04C2 Owner's Manual

4. Configuration

Initially, the new device connects the network using default IP (192.168.0.254). Access
the IP address to enter the Wizard. After three seconds the "Welcome" screen will switch
to the set-up screen as shown below. The following flow chart illustrates the installation
and subsequent steps after plug in.

4.1. Wizard Settings

Wizard will be use full to configure basic settings in the device like switch User account
with host name, management IP, And access Mode. The Wizard assisted interface covers
the basic requirements for most end-users to set up the Ethernet switch in these three
steps; 1) Account; 2) IP address; 3) Access Mode.
Step 1: Account Settings to configure user credentials to access the device, which will
guide you the strength of security.
21