How To Remove The Platform - All Other Models - Terex Genie GS-1330m Service And Repair Manual

Service and Repair Manual
Platform Components
How to Remove the Platform - How to Re mov e th e Platfo rm - All ot her mod els
All other models
Perform this procedure with the platform extension
fully retracted and locked in position.
1 Raise the platform to approximately 3 ft / 1 m.
2 Remove the retaining fasteners securing the
platform to the platform mount at the steer
end of the machine.
3 Lower the platform to the stowed position.
4 Disconnect the battery pack from the
machine.
Electrocution/burn hazard.
Contact with electrically charged
circuits could result in death or
serious injury. Remove all rings,
watches and other jewelry.
5 Disconnect the platform controls from the
control cable at the platform.
6 Remove the cover from the AC outlet. Tag
and disconnect the wiring from the outlet.
Electrocution/burn hazard.
Contact with electrically charged
circuits could result in death or
serious injury. Remove all rings,
watches and other jewelry.
7 Disconnect the wiring from the platform and
pull the wiring free of the platform.
8 Models with air line to platform option:
Disconnect the air line from the platform. Pull
the air line free of the platform.
168
9
10 Attach a strap from the lanyard anchorage
11 GS-1530, GS-1532, GS-1930, GS-1932, GS-
12 Carefully lift the platform off of the machine
Note: Take notice of the wear pad position before
the platform is removed. Correct wear pad position
is essential for proper platform functionality.
GS ™ -30m • 32m • 30 • 32 • 46 • 55
Support the platform with a forklift at the non-
steer end. Do not apply any lifting pressure.
point on the platform railings to the carriage
on the forklift to help support the platform.
1932 XH: Lift the steer end of the platform
slightly to clear the platform mount and slide
the platform towards the non-steer end of the
machine until the platform slide blocks at the
non-steer end of the machine are visible
through the access holes in the bottom of the
platform.
All other models: Lift the steer end of the
platform slightly to clear the platform mount
and slide the platform towards the steer end
of the machine until the platform slide blocks
at the non-steer end of the machine are
visible through the access holes in the bottom
of the platform.
Crushing hazard. The platform
will fall if not properly supported.
and place it on a structure capable of
supporting it.
August 2021
Part No. 1309020GT