Terex Genie GS-1330m Service And Repair Manual page 164

Service and Repair Manual
Scissor Components
20 Remove the lifting device supporting the link
stack at the steer end of the machine.
21 Connect the battery pack to the machine.
22 Press and hold the ground control scroll up
and scroll down buttons.
23 Pull out the red Emergency Stop button to the
on position at the ground controls.
24 Using the ground control menu buttons,
navigate to Service Override Mode. Select
Service Override Mode.
Note: The machine must be in Service Override
Mode to raise the platform. While in Service
Override Mode, only the GCON will operate with
limited functionality. The platform will raise a
predetermined amount of time and stop.
25 Raise the platform and rotate the safety arm
to the stowed position.
26 Fully lower the platform to the stowed
position.
27 Calibrate the platform overload system. Refer
to Repair Procedure How to Calibrate the
Platform Overload System.
150
GS-3232, GS-3246, GS-3246 XH
Note: When removing a hose assembly or fitting,
the O-ring (if equipped) on the fitting and/or hose
end must be replaced. All connections must be
torqued to specification during installation. Refer to
Specifications, Hydraulic Hose and Fitting Torque
Specifications.
1
2
GS ™ -30m • 32m • 30 • 32 • 46 • 55
Bodily injury hazard. The
procedures in this section
require specific repair skills,
lifting equipment and a suitable
workshop. Attempting this
procedure without these skills
and tools could result in death or
serious injury and significant
component damage. Dealer
service is required.
Turn the key switch to ground controls and
pull out the red Emergency Stop button to the
on position at both ground and platform
controls.
Raise the platform 7 to 9 feet / 2,1 to 2,8 m.
August 2021
Part No. 1309020GT