Terex Genie GS-1330m Service And Repair Manual page 94

Service and Repair Manual
Scissor Components
74 Remove the pin retaining fasteners from the
lift cylinder barrel-end pin (index #21). Use a
soft metal drift to remove the pin. Remove the
lift cylinder from the machine.
Crushing hazard. The lift
cylinder will become unbalanced
and fall if not properly supported
and secured to the lifting device.
Component damage hazard. Be
careful not to damage the valve
or fittings on the cylinder while
removing it from the machine.
75 Place a 4 x 4 x 48 inch / 10 cm x 10 cm x
1.2 m long block across both sides of the
chassis under the number 1 center pivot pin
(index #11).
76 Attach a lifting strap from an overhead
supporting device to the number 1 inner arm
(index #10) at the non-steer end. Raise the
number 1 inner arm and remove the safety
arm. Lower the number 1 inner arm (index
#10) onto the block that was placed across
the chassis.
Bodily injury hazard. Keep
hands clear of moving parts
when lowering the scissor arms.
77 Remove the cables from the number 1 cable
bridge and lay them off to the side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
78 Support and secure the entry ladder to an
appropriate lifting device.
80
79 Remove the fasteners from the entry ladder
80 Attach a lifting strap from an overhead
81 Remove the external snap rings and retaining
82 Remove the number 1 cable bridge from the
83 Use a soft metal drift to remove the number
84 Slide the number 1 outer arm (index #22) to
85 Attach the strap from an overhead supporting
GS ™ -30m • 32m • 30 • 32 • 46 • 55
and remove the entry ladder from the
machine.
Crushing hazard. The entry
ladder will fall if not properly
supported and secured to the
lifting device.
supporting device to the number 1 outer arm
(index #22). Do not apply any lifting pressure.
fasteners from the number 1 center pivot pins
(index #11).
machine.
1 center pivot pins (index #9).
Bodily injury hazard. The
number 1 outer arm may
become unbalanced and fall if
not properly supported when the
pin is removed.
the non-steer end and remove it from the
machine.
Bodily injury hazard. The
number 1 outer arm may
become unbalanced and fall if
not properly supported when
removed from the machine.
device to the number 1 inner arm (index #10).
Do not lift it.
August 2021
Part No. 1309020GT