Platform Height Sensor; How To Disassemble The Platform Height Sensor Assembly - Gs-1432M, Gs-1932M, Gs-1932M Lite, Gs-1932M Xh - Terex Genie GS-1330m Service And Repair Manual

Service and Repair Manual
Scissor Components
9-12

Platform Height Sensor

How to Disassemble the Platform How to Disa ssem ble t he Platf or m Heig ht Sens or Ass embly - GS- 143 2m, GS-1 932 m, GS- 193 2m Lite, GS-19 32m XH
Height Sensor Assembly - GS-
1432m, GS-1932m, GS-1932m
Lite, GS-1932m XH
Note: When a Platform Height Sensor Assembly is
removed or replaced, the platform overload
system must be calibrated. Refer to Repair
Procedure, How to Calibrate the Platform
Overload System and perform the no load
calibration procedure.
1 Raise the platform 7 to 9 feet / 2,1 to 2,8 m.
2 Raise the safety arm from the drive chassis to
a vertical position.
3 Lower the platform onto the safety arm.
Crushing hazard. Keep hands
clear of the safety arm when
lowering the platform.
4 Turn the key switch to the off position.
5 Disconnect the battery pack from the
machine.
Electrocution/burn hazard.
Contact with electrically charged
circuits could result in death or
serious injury. Remove all rings,
watches and other jewelry.
6 Remove the fasteners securing the platform
height sensor cover to the chassis.
142
7
8
9
10 Remove the fasteners securing the platform
11 Remove the set screw securing the lever arm
GS ™ -30m • 32m • 30 • 32 • 46 • 55
Remove the platform height sensor cover.
1 retaining fasteners
2 cover
Tag and disconnect the platform height
sensor from the platform height sensor
harness.
Remove the fastener securing the platform
height sensor assembly to the number 1 inner
arm.
height sensor assembly to the platform height
sensor plate.
to the platform height sensor.
August 2021
Part No. 1309020GT