Terex Genie GS-1330m Service And Repair Manual page 91

August 2021
27 Attach a lifting strap from an overhead
supporting device to the number 4 outer arm
(index #13).
28 Remove the external snap rings and retaining
fasteners from the number 4 center pivot pins
(index #2).
29 Use a soft metal drift to remove the number
4 center pivot pins (index #2).
30 Remove the retaining fasteners from the
number 4 pivot pin (index #14) at the non-
steer end of the machine.
31 Use a soft metal drift to remove the number
4 pivot pin (index #14) from the non-steer end
of the machine. Remove the number 4 outer
arm (index #13) from the machine.
Crushing hazard. The number
4 outer arm may become
unbalanced and fall if not
properly supported when
removed from the machine.
32 Remove the number 4 cable bridge mounting
fasteners and remove the cable bridge from
the machine.
33 Attach a lifting strap from an overhead
supporting device to the number 4 inner arm
(index #12).
34 Remove the retaining fasteners from the
number 4 pivot pin (index #3).
35 Use a soft metal drift to remove the number
4 pivot pin (index #3) at the steer end.
Remove the number 4 inner arm (index #12)
from the machine.
Crushing hazard. The number
4 inner arm may become
unbalanced and fall if not
properly supported when
removed from the machine.
Part No. 1309020GT
36 Remove the cables from the number 3 cable
37 Remove the number 3 cable from the
38 Attach a lifting strap from an overhead
39 Remove the external snap rings and retaining
40 Use a soft metal drift to remove the number
41 Use a soft metal drift to tap the number
42 Attach a lifting strap from an overhead
43 Use a soft metal drift to tap the number
GS ™ -30m • 32m • 30 • 32 • 46 • 55
Service and Repair Manual
Scissor Components
bridge and number 3 inner arm and lay them
off to the side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
machine.
supporting device to the number 3 outer arm
(index #4) at the ground controls side.
fasteners from the number 3 center pivot pin
(index #4).
3 center pivot pin (index #4) at the ground
control side.
3 pivot pin (index #17) halfway out at the non-
steer end of the machine. Remove the
number 3 outer arm (index #16) at the ground
controls side from the machine.
Bodily injury hazard. The
number 3 outer arm at the
ground controls side may
become unbalanced and fall if
not properly supported when
removed from the machine.
supporting device to the number 3 outer arm
(index #16) at the battery pack side.
3 pivot pin (index #17) in the other direction.
Remove the number 3 outer arm (index #16)
from the battery pack side of the machine.
Bodily injury hazard. The
number 3 outer arm at the
battery pack side may become
unbalanced and fall if not
properly supported when
removed from the machine.
77