Terex Genie GS-1330m Service And Repair Manual page 101

August 2021
20 Pull out the red Emergency Stop button to the
on position at the ground controls.
21 Using the ground control menu buttons,
navigate to Service Override Mode. Select
Service Override Mode.
Note: The machine must be in Service Override
Mode to raise the platform. While in Service
Override Mode, only the GCON will operate with
limited functionality. The platform will raise a
predetermined amount of time and stop.
22 Raise the platform and rotate the safety arm
to the stowed position.
23 Fully lower the platform to the stowed
position.
Cable bridge and platform height sensor
1 cable bridge 3
2 cable bridge 2
3 cable bridge 1
4 platform height sensor
Part No. 1309020GT
24 Remove the platform. Refer to Repair
25 Remove the cables from the number 3 outer
26 Remove the cables from the number 3 cable
27 Attach a lifting strap from an overhead
28 Remove the external snap rings and retaining
29 Use a soft metal drift to remove the number
30 Remove the retaining fasteners from the
31 Use a soft metal drift to remove the number
32 Remove the number 3 cable bridge mounting
33 Attach a lifting strap from an overhead
GS ™ -30m • 32m • 30 • 32 • 46 • 55
Service and Repair Manual
Scissor Components
Procedure, How to Remove the Platform.
arm (index #11) at the ground controls side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
bridge and lay them off to the side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
supporting device to the number 3 outer arm
(index #11).
fasteners from the number 3 center pivot pins
(index #2).
3 center pivot pins (index #2).
number 3 pivot pin (index #12) at the non-
steer end of the machine.
3 pivot pin (index #12) from the non-steer end
of the machine. Remove the number 3 outer
arm (index #11) from the machine.
Crushing hazard. The number
3 outer arm may become
unbalanced and fall if not
properly supported when
removed from the machine.
fasteners and remove the cable bridge from
the machine.
supporting device to the lug on the rod end of
the lift cylinder for support. Do not apply any
lifting pressure.
87