Terex Genie GS-1330m Service And Repair Manual page 51

August 2021
11 Install the level sensor retaining fasteners
through the level sensor and into the mount
bracket.
12 Connect the chassis wire harness to the level
sensor.
13 Turn the key switch to ground control and pull
out the red Emergency Stop button to the on
position at both ground and platform controls.
Result: GCON will display a 'C051:
SYSTEMFAULT, TILT:NoCal fault.
14 Push in the red Emergency Stop button to the
off position at the ground controls.
15 Press and hold the ground control scroll up
and scroll down buttons.
Ground Control Menu Buttons
1 scroll down button
2 enter button
3 scroll up button
4 escape button
5 LCD display
Part No. 1309020GT
16 Pull out the red Emergency Stop button to the
17 Release the Scroll Up and Scroll Down
18 Use the Scroll Up or Scroll Down buttons to
19 Press the enter button.
20 Use the Scroll Up or Scroll Down buttons to
21 Press the enter button.
GS ™ -30m • 32m • 30 • 32 • 46 • 55
Service and Repair Manual
Ground Controls
on position at the ground controls.
Result: The ground controls LCD display will
show the following:
buttons after the ground controller powers up.
scroll to Select Option.
scroll to Tilt Sensor.
37