Terex Genie GS-1330m Service And Repair Manual page 111

August 2021
73 Tag and disconnect the wires and manual
lowering cable from the solenoid valve on the
cylinder.
74 Tag and disconnect the wire harness from the
platform overload pressure transducer.
75 Raise the lift cylinder to a vertical position.
76 Remove the pin retaining fasteners from the
lift cylinder barrel-end pin (index #21). Use a
soft metal drift to remove the pin. Remove the
lift cylinder from the machine.
Crushing hazard. The lift
cylinder will become unbalanced
and fall if not properly supported
and secured to the lifting device.
Component damage hazard. Be
careful not to damage the valve
or fittings on the cylinder while
removing it from the machine.
77 Place a 4 x 4 x 48 inch / 10 cm x 10 cm x
1.2 m long block across both sides of the
chassis under the number 1 center pivot pin
(index #11).
78 Attach a lifting strap from an overhead
supporting device to the number 1 inner arm
(index #10) at the non-steer end. Raise the
number 1 inner arm and remove the safety
arm. Lower the number 1 inner arm (index
#10) onto the block that was placed across
the chassis.
Bodily injury hazard. Keep
hands clear of moving parts
when lowering the scissor arms.
Part No. 1309020GT
79 Remove the cables from the number 1 cable
80 Support and secure the entry ladder to an
81 Remove the fasteners from the entry ladder
82 Attach a lifting strap from an overhead
83 Remove the external snap rings and retaining
84 Remove the number 1 cable bridge from the
85 Use a soft metal drift to remove the number
86 Slide the number 1 outer arm (index #22) to
GS ™ -30m • 32m • 30 • 32 • 46 • 55
Service and Repair Manual
Scissor Components
bridge and lay them off to the side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
appropriate lifting device.
and remove the entry ladder from the
machine.
Crushing hazard. The entry
ladder will fall if not properly
supported and secured to the
lifting device.
supporting device to the number 1 outer arm
(index #22). Do not apply any lifting pressure.
fasteners from the number 1 center pivot pins
(index #11).
machine.
1 center pivot pins (index #9).
Bodily injury hazard. The
number 1 outer arm may
become unbalanced and fall if
not properly supported when the
pin is removed.
the non-steer end and remove it from the
machine.
Bodily injury hazard. The
number 1 outer arm may
become unbalanced and fall if
not properly supported when
removed from the machine.
97