Thrust Washers - Gs-1432M, Gs-1932M, Gs-1932M Lite, Gs-1932M Xh - Terex Genie GS-1330m Service And Repair Manual

August 2021
2 Locate and remove the two brake release
access plugs on the front of the electric drive
motors. Set the plugs aside.
Note: Do not misplace the plugs. Failure to not
reinstalling the plugs will result in component
damage.
1 retaining fasteners
2 brake release access plugs
3 Remove two of the retaining fasteners from
opposite sides of the electric motor cover.
4 Install the retaining fasteners into the brake
release access holes. Turn both fasteners in
even increments until the brakes are
released. Do not over tighten the fasteners.
5 Move the machine to an area that has a firm,
level surface and is free of obstructions.
6 Chock the wheels at both ends of the
machine.
7 Remove the retaining fasteners from the
brake release access holes to reengage the
brakes.
8 Install the retaining fasteners securing the
motor cover and the brake release access
plugs.
Part No. 1309020GT
6-6
Thrust Washers - GS-1432m, GS-
1932m, GS-1932m Lite, GS-1932m
XH
How to Remove a Thrust Washer
1
2
3
4
5
GS ™ -30m • 32m • 30 • 32 • 46 • 55
Service and Repair Manual
Steer Axle Components
Remove the drive motor. Refer to Repair
Procedure, How to Remove a Drive Motor.
Remove the steer bellcrank. Refer to Repair
Procedure, How to Remove the Steer
Bellcrank.
Remove the snap rings and shims from the
king pin.
Remove the yoke assembly from the
machine.
Remove the thrust washer from the king pin.
71