Terex Genie GS-1330m Service And Repair Manual page 146

Service and Repair Manual
Scissor Components
95 Remove the number 2 outer arm (index #31)
from the machine.
Crushing hazard. The number
2 outer arm (index #31) may
become unbalanced and fall if
not properly supported when
removed from the machine.
96 Attach a lifting strap from an overhead
supporting device to the number 2 inner arm
(index #30). Raise the arm to a vertical
position.
97 Remove the retaining fasteners from the
number 2 pivot pin at the steer end of the
machine (index #14).
98 Use a soft metal drift to remove the number
2 pivot pin (index #14) from the steer end of
the machine. Remove the number 2 inner arm
(index #30) from the machine.
Crushing hazard. The number
2 inner arm (index #30) may
become unbalanced and fall if
not properly supported when the
pivot pin is removed.
99 Attach a lifting strap from an overhead
supporting device to the number 1 inner arm
(index #16).
100 Raise the number 1 inner arm (index #16)
approximately 2 feet / 60 cm.
101 Place a 4 x 4 x 48 inch / 10 cm x 10 cm x
1.2 m long block across both sides of the
chassis under the number 1 center pivot pin
(index #15).
102 Lower the scissor arms onto the block that
was placed across the chassis.
Bodily injury hazard. Keep
hands clear of moving parts
when lowering the scissor arms.
103 Attach a lifting strap from an overhead
supporting device to the lug of the rod end of
the lower lift cylinder.
132
104 Tag, disconnect and plug the hydraulic hose
105 Tag and disconnect the wire harness from
106 Tag and disconnect the wires and manual
107 Tag and disconnect the wire harness from
108 Raise the lift cylinder to a vertical position.
109 Remove the pin retaining fasteners from the
110 Remove the cables from the number 1 cable
GS ™ -30m • 32m • 30 • 32 • 46 • 55
on the lower lift cylinder. Cap the fittings on
the cylinder.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
the solenoid valve on the cylinder.
lowering cable from the solenoid valve on the
cylinder.
the platform overload pressure transducer.
lift cylinder barrel-end pivot pin (index #28).
Use a soft metal drift to remove the pin.
Remove the lift cylinder from the machine.
Crushing hazard. The lift
cylinder will fall if not properly
supported when the pivot pin is
removed.
Component damage hazard. Be
careful not to damage the valve
or fittings on the cylinder while
removing it from the machine.
bridge and lay them off to the side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
August 2021
Part No. 1309020GT