Terex Genie GS-1330m Service And Repair Manual page 93

August 2021
61 Use a soft metal drift to tap the number
2 pivot pin (index #20) in the other direction at
the non-steer end. Remove the number
2 outer arm (index #19) from the battery pack
side of the machine.
Bodily injury hazard. The
number 2 outer arm at the
battery pack side may become
unbalanced and fall if not
properly supported when
removed from the machine.
62 Remove the number 2 pivot pin (index #20)
from the non-steer end of the machine.
63 Attach a lifting strap from an overhead
supporting device to the number 2 inner arm
(index #18).
64 Remove the retaining fasteners from the
number 2 pivot pin (index #8) at the steer end
of the machine.
65 Use a soft metal drift to remove the number
2 pivot pin (index #8). Remove the number
2 inner arm (index #18) from the machine.
Bodily injury hazard. The
number 2 inner arm may
become unbalanced and fall if
not properly supported when
removed from the machine.
66 Remove the safety arm from the number
2 inner arm (index #18) that was just
removed.
67 Attach a lifting strap from an overhead
supporting device to the number 1 inner arm
(index #10).
Part No. 1309020GT
68 Raise the number 1 inner arm (index #10)
69 Attach a lifting strap from an overhead
70 Tag, disconnect and plug the hydraulic hoses
71 Tag and disconnect the wires and manual
72 Tag and disconnect the wire harness from the
Note: After replacing the scissor assembly, the
platform overload system must be calibrated.
Refer to Repair Procedure, How to Calibrate the
Platform Overload System.
73 Raise the lift cylinder to a vertical position.
GS ™ -30m • 32m • 30 • 32 • 46 • 55
Service and Repair Manual
Scissor Components
approximately 2 feet / 60 cm and install the
safety arm between the number 1 inner arm
(index #10) and the number 1 outer arm
(index #22) at the non-steer end of the
machine. Lower the scissor arms onto the
safety arm.
Bodily injury hazard. Keep
hands clear of moving parts
when lowering the scissor arms
onto the safety arm.
supporting device to the lug on the rod end of
the lift cylinder (index #5). Raise the lift
cylinder approximately 3 ft / 1 m.
on the lift cylinder. Cap the fittings on the
cylinder.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
lowering cable from the solenoid valve on the
cylinder.
platform overload pressure transducer.
79