Terex Genie GS-1330m Service And Repair Manual page 108

Service and Repair Manual
Scissor Components
27 Attach a lifting strap from an overhead
supporting device to the number 4 outer arm
(index #13).
28 Remove the external snap rings and retaining
fasteners from the number 4 center pivot pins
(index #2).
29 Use a soft metal drift to remove the number
4 center pivot pins (index #2).
30 Remove the retaining fasteners from the
number 4 pivot pin (index #14) at the non-
steer end of the machine.
31 Use a soft metal drift to remove the number
4 pivot pin (index #14) from the non-steer end
of the machine. Remove the number 4 outer
arm (index #13) from the machine.
Crushing hazard. The number
4 outer arm may become
unbalanced and fall if not
properly supported when
removed from the machine.
32 Remove the number 4 cable bridge mounting
fasteners and remove the cable bridge from
the machine.
33 Attach a lifting strap from an overhead
supporting device to the number 4 inner arm
(index #12).
34 Remove the retaining fasteners from the
number 4 pivot pin (index #3).
35 Use a soft metal drift to remove the number
4 pivot pin (index #3) at the steer end.
Remove the number 4 inner arm (index #12)
from the machine.
Crushing hazard. The number
4 inner arm may become
unbalanced and fall if not
properly supported when
removed from the machine.
94
36 Remove the cables from the number 3 cable
37 Remove the number 3 cable bridge mounting
38 Attach a lifting strap from an overhead
39 Remove the external snap rings and retaining
40 Use a soft metal drift to remove the number
41 Remove the retaining fasteners from the
42 Use a soft metal drift to tap the number
43 Attach a lifting strap from an overhead
44 Use a soft metal drift to remove the number
GS ™ -30m • 32m • 30 • 32 • 46 • 55
bridge and lay them off to the side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
fasteners and remove the cable bridge from
the machine.
supporting device to the number 3 outer arm
(index #4) at the ground controls side.
fasteners from the number 3 center pivot pins
(index #4).
3 center pivot pin (index #4) at the ground
control side.
number 3 pivot pin (index #17) at the non-
steer end of the machine.
3 pivot pin (index #17) halfway out at the non-
steer end of the machine. Remove the
number 3 outer arm (index #16) at the ground
controls side from the machine.
Bodily injury hazard. The
number 3 outer arm at the
ground controls side may
become unbalanced and fall if
not properly supported when
removed from the machine.
supporting device to the number 3 outer arm
(index #16) at the battery pack side.
3 center pivot pin (index #4) at the battery
pack side of the machine.
August 2021
Part No. 1309020GT