Terex Genie GS-1330m Service And Repair Manual page 102

Service and Repair Manual
Scissor Components
34 Remove the pin retaining fasteners from the
lift cylinder rod-end pivot pin (index #3). Use a
soft metal drift to remove the pin.
Bodily injury hazard. The
cylinder may fall when the rod-
end pivot pin is removed if not
properly supported.
35 Lower the cylinder onto the number 1 inner
arm (index #8).
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
36 Attach a lifting strap from an overhead
supporting device to the number 3 inner arm
(index #10).
37 Remove the retaining fasteners from the
number 3 pivot pin (index #4) at the steer end.
38 Use a soft metal drift to remove the number
3 pivot pin (index #4). Remove the number
3 inner arm (index #10) from the machine.
Bodily injury hazard. The
number 3 inner arm may
become unbalanced and fall if
not properly supported when
removed from the machine.
39 Remove the cables from the number 2 cable
bridge and lay them off to the side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
40 Remove the external snap rings and retaining
fasteners from the number 2 center pivot pin
(index #5) at the ground controls side.
41 Remove the number 2 cable bridge mounting
fasteners and remove the cable bridge from
the machine.
88
42 Attach a lifting strap from an overhead
43 Use a soft metal drift to remove the number
44 Remove the retaining fasteners from the
45 Use a soft metal drift to tap the number
46 Attach a lifting strap from an overhead
47 Remove the external snap rings and retaining
48 Use a soft metal drift to remove the number
GS ™ -30m • 32m • 30 • 32 • 46 • 55
supporting device to the number 2 outer arm
(index #14) at the ground controls side.
2 center pivot pin (index #5) at the ground
controls side.
number 2 pivot pin (index #15) at the non-
steer end of the machine.
2 pivot pin (index #15) halfway out at the non-
steer end of the machine. Remove the
number 2 outer arm (index #14) from the
ground controls side of the machine.
Bodily injury hazard. The
number 2 outer arm at the
ground controls side may
become unbalanced and fall if
not properly supported when
removed from the machine.
supporting device to the number 2 outer arm
(index #14) at the battery pack side.
fasteners from the number 2 center pivot pin
(index #5) at the battery pack side.
2 center pivot pin (index #5) at the battery
pack side.
Bodily injury hazard. The
number 2 outer arm at the
battery pack side may become
unbalanced and fall if not
properly supported when
removed from the machine.
August 2021
Part No. 1309020GT